Clipacore Waste Removal Knockout Tool - QCKOT

Pilot hole drilling depths must be kept to a minimum. Avoid soft mortar joints aligning with pin.

The Clipacore Debris Knockout Tool is designed to fit inside the core adaptors, upon disconnecting from the drill adaptor. The adaptor which comes with the long impact pin helps guide the pin and protect the end face of core adaptor from damage.

The pin can be used on hard substrates such as concrete block or brick work and not advised to use on soft mortar joints if central of core bit as this may affect removal. TGQCKOT

THIS OVERCOMES THE NEED FOR HAMMERING CORE BITS AND DENTING THEM, WHICH CAUSES RESISTANCE AND THE DRILL TO LOCK UP!

• ClipaCore the industry-first Diamond Core clip release system, manufactured to the highest engineering standards in Great Britain
• ClipaCore is 100% compatible with existing 1/2″ diamond tipped core sets and power tools, upgrading today’s tools into the 21st century
• Clipacore a growing family, enabling installers to select across the range of products to suit their toolset and working needs
• ClipaCore used by professional tradespeople protecting their tools, saving working time and offering personnel protection
• ClipaCore offers the professional tradesperson the products they need whenever diamond core drilling

Important:

• Please pay close attention when using 42mm core bits as the clip could make contact with the wall during use, causing damage beyond repair
• The Knockout tool has been designed for use on brickwork and solid blockwork only. Soft Mortar joints aligning central with the core bit may affect the knock out tool removing the unwanted waste material
• Periodically apply plumbers silicone grease to circlip pin and the spigot end of the drill adaptor only. This will help protect the moving parts from dust and particles and extend the life of your purchased product
• Due to the high RPM and vibration, the quick release clip has been designed to be a tight fit so as not to come off in use. Always attach the quick release clip to the core adaptors when the core adaptors are connected to a core bit and never straight out of the packaging
• When using dust extraction units attached to a core drill, please be advised there is a loss of suction due to the pin inevitably covering the drill aperture
• The adaptors are designed for dry core cutting only and not to be used in conjunction with water fed systems
• The clips are designed to be removed and prised off by hand only (not by the use of tools). Using hammers or screwdrivers could break the clip